Case study : TIVAR® 1000
UHMW-PE + SBR (styrene-butadiene rubber): Rubber Back Sheet developing process
There is many cases that when Attaching lining material to small flection part, thin rubber back sheet is required. UHMW-PE can’t be attached with bond to opponent material. UHMW-PE is required with bolt when it lined. Lining UHM-PE with bolt sometime caused non-good sliding property in consequence of adherence on holed bolt part.
We developed composite material by bonding UHMW-PE and SBR. SBR can be attached to opponent material by bond. Weak point UHMW-PE, CLTE can be refrained from this composite structure as little as possible.
|Liner:||TIVAR® 1000 (2mm) + SBR (1mm) x 900 x 1800|
|Bulk Material:||feedstuff of cow|
Feedstuff laid down on a trough and vent
Mitsubishi Chemical Advanced Materials’ solution
Providing Semi finished parts, Install time could be shorten. Fulfilled Customized size required.
Important: Most plastics will ignite and sustain flame under certain conditions. Caution is urged where any material may be exposed to open flame or heat generating equipment. Use Material Safety Data Sheets to determine auto-ignition and flashpoint temperatures of material or consult Mitsubishi Chemical Advanced Materials. WARRANTY: Characteristics and applications for products are shown for information only and should not be viewed as recommendations for use or fitness for any particular purpose. TIVAR® and SystemTIVAR® are registered trademarks of Mitsubishi Chemical Advanced Materials